CCNA Practice Quiz: 200-301 Quiz 3

1. You are deploying a new 10GB Ethernet network using Cat 6 cabling. Which of the following are true concerning this media? (Choose two)

• It uses twisted 18- or 16-gauge copper wiring.
• PVC insulation surrounds each copper wire.
• It is completely immune to EMI.
• It supports 10 GB Ethernet connections.
• It supports multi-mode transmissions.

2. Which fiber optic cable requires the exposed fiber tip to be polished as part of the assembly process?

• Field terminated epoxy connectors
• Pre-polished connectors
• Only plastic core fiber connectors
• RJ-45 connectors

3. As specified in the Ethernet standards, what is the maximum number of hosts supported on a single subnet?

• 1024
• 100
• 254
• 512

4. After the completion of regularly scheduled maintenance on a router, you want to remove the message-of-the-day (MOTD) banner. Which command will accomplish that task?

• banner motd *clear*
• remove banner motd
• banner motd clear
• no banner motd

5. Which of the following is the most important thing to do to prevent console access to the router?

• Disconnect the console cable when not in use.
• Keep the router in a locked room.
• Set the console and enable secret passwords.
• Implement an access list to prevent console connections.

6. A workstation has been assigned the following IP addressing information:

IP address: 192.168.1.26
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.254
DNS server: 192.168.1.1

Given this information, what is the network IP address of this workstation?

• 192.168.1.255
• 192.168.0.0
• 192.0.0.0
• 192.168.1.0

7. You have a workstation connected to a small branch network using a single switch. The network does not have any routers and is not connected to the internet. What are the minimum configuration parameters required on the workstation to be able to communicate with all hosts on the network?

• IP address and subnet mask
• IP address, subnet mask, and default gateway
• IP address
• IP address and default gateway

8. Which of the following best describes a hop count?

• Is determined based on the bandwidth of the available connections.
• Required by the router to process each received frame individually.
• Examines the destination address and refers to its routing table.
• The number of routers needed to get to the destination network.

9. EIGRP uses a neighbor's table to keep track of neighbor routers. Which of the following helps the router identify cost values to reach each neighbor in the routing table?

• Split horizon
• Convergence
• Round-trip timers
• Hold time

10. What does EIGRP use to send partial routing updates?

• FD
• FTP
• AD
• RTP