CCNA Practice Quiz: 200-301 Quiz 2

1. The process of breaking a message into packets, adding control information and other information, and then transmitting the message through the transmission medium is known as which of the following?

• Sequencing
• Transformation
• Encapsulation
• Segmentation

2. What is the purpose of a frame check sequence (FCS) footer?

• Contains logical network addresses
• Checksum error detection
• Holds segment data
• Control information

3. Which two of the following statements accurately describe half-duplex Ethernet? (Choose two)

• It does not require collision detection.
• It sends both signals along the same wire.
• It lets you use 100 percent of the available bandwidth for data transmission.
• It uses collision detection and recovery.
• It uses direct point-to-point connections between the sender and receiver.

4. What is the maximum cable length for UTP Ethernet T implementations?

• 40 kilometers
• 300 meters
• 10 kilometers
• 100 meters

5. Which of the following configuration register values tells the router to use configuration information from NVRAM?

• 0x42
• 0x2101
• 0x001
• 0x2102

6. While working at the console of a Cisco device, you need to view a list of the commands that are available in the current mode. Which command should you use?

• ?
• show history
• terminal editing
• terminal history

7. Your network uses a network address of 137.65.0.0 with a subnet mask of 255.255.0.0. How many IP addresses are available for assignment to network hosts on this network?

• 254
• 16777214
• 2
• 65534

8. Terry is using the EIGRP routing protocol. Terry wants to use a single route to represent multiple routes to reduce the size of routing tables in the network. Which of the following routing summarization methods is being used?

• Automatic
• Manual
• auto-summary
• ip summary-address

9. Which of the following commands can be used to enable IPv6 routing on Cisco equipment?

• ipv6 unicast-routing
• ipv6 address
• ipv6 enable
• ipv6 route

10. You need to place a wireless access point in your two-story building. While trying to avoid interference, which of the following is the best location for the access point?

• In the kitchen area
• Near the backup generators
• In the basement
• On the top floor